Select Lever: Assembly

WARNING: This page is about a different car, the 2014 Subaru Forester. However, it is still accessible from the selected car via links, so may be relevant.

Clean all the parts before assembly.
Apply Multemp D or equivalent to the sliding portion of each part.
Assemble in the reverse order of disassembly.
NOTE: Insert the solenoid unit terminals to the harness connector.

Fig 1: Inserting Solenoid Unit Terminals To Harness Connector
Courtesy of SUBARU OF AMERICA, INC.
After installation, check the following points.
- The select indicator matches the select lever position when the select lever is changed from "P" range to "D" range.
- The select lever position and the position mark match each other.
- Operating force to move the select lever from "P" to "D" range.