Description of functions

WARNING: This page is about a different car, the 2014 Subaru BRZ. However, it is still accessible from the selected car via links, so may be relevant.

The ABS solenoid relay is integrated into the brake actuator Assembly and supply power to the ABS solenoid.

After turning IG ON, if the solenoid has been judged as normal by self-diagnosis during initial check, turn the relay ON. If open or short circuit has been detected, turn the relay OFF.

If the power supply voltage for the ABS solenoid relay drops due to the battery or alternator's insufficient output, this code may be stored in memory.

Diagnostic codes	DTC detecting conditions	Faulty part
C146E	The ABS solenoid relay driving circuit in the skid control computer (brake actuator Assembly) does not operate normally. The ABS solenoid relay cannot be turned ON/OFF.	ABS No. 2 fuse Wiring harness or connector Skid control computer (brake actuator Assembly)