Rearview Camera System: Inspection

Park the vehicle at the level place where there are enough area at the rear of the vehicle.
Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.
NOTE: Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.

Fig 1: Identifying Standard Tape Width
Courtesy of SUBARU OF AMERICA, INC.
Confirm the following before checking the corresponding items.

When the display is blank:
Rearview camera image is not displayed. (The multi-function display screen is displayed normally.)
- Check the condition of back sensor and rearview camera connection. <Ref. to DIAGNOSTIC MODE , OPERATION, Multi-function Display (MFD) System.>
When the marker position is not aligned:
- Adjust the marker position according to the MARKER ADJUSTMENT MODE. <Ref. to DIAGNOSTIC MODE , OPERATION, Multi-function Display (MFD) System.>