Rearview Camera System: Inspection
- Park the vehicle at the level place where there are enough area at the rear of the vehicle.
- Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.NOTE: Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.
- Confirm the following before checking the corresponding items.
- When the display is blank:
Rearview camera image is not displayed. (The multi-function display screen is displayed normally.)
- Check the condition of back sensor and rearview camera connection. <Ref. to DIAGNOSTIC MODE , OPERATION, Multi-function Display (MFD) System.>
- When the marker position is not aligned:
- Adjust the marker position according to the MARKER ADJUSTMENT MODE. <Ref. to DIAGNOSTIC MODE , OPERATION, Multi-function Display (MFD) System.>