LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2015 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Air Bag System (Service Information)) >> Driver's Airbag Module >> Installation
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Driver's Airbag Module: Installation

WARNING: This page is about a different car, the 2016 Subaru Outback and 2016 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
  • Refer to "CAUTION" of "General Description" before handling the airbag system components. < Ref. to CAUTION , General Description. >
  • Do not allow harness and connectors to interfere or get tangled up with other parts.
  1. Before installation, inspect the following items and replace any faulty part with a new one.
    • Airbag module is cracked or deformed.
    • Harness and/or connector is cracked, deformed or open.
    • Harness wire is exposed.
    • The steering wheel is in the way, making it difficult to install the airbag module.
    • The clearance between the driver's airbag module and steering wheel is not constant.
  2. Install the driver's airbag module.
    1. Connect the airbag connector to the airbag module securely.
      CAUTION:
      • Be sure to insert the connector in until it is locked.
      • Press in the push lock securely. Then pull it gently to make sure that it is locked.
    2. Connect the horn harness.
    3. Press in the locks (three positions) to install the airbag module.
      CAUTION: Make sure that the airbag module locks (three positions) are securely locked.
  3. Connect the ground terminal to battery sensor. < Ref. to BATTERY , NOTE, Repair Contents. >
scientia non olet · About LEMON Manuals