Door Switch: Inspection

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Measure the resistance between connector terminals.

Preparation tool:

Circuit tester

Fig 1: Identifying Door Switch Connector Terminals

Courtesy of SUBARU OF AMERICA, INC.

Terminal No.	Inspection conditions	Standard
Front LH: 1 - 2 Except for front LH: 1 - 4	When the switch is not pressed	Less than 1 Ω
Front LH: 1 - 2 Except for front LH: 1 - 4	When the switch is pressed	1 MΩ or more

Replace the switch assembly - door if the inspection result is not within the standard value.