Rearview Camera System: Inspection

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

Park the vehicle at a level place where there are enough area at the rear of the vehicle.
Attach the tape as the target point for standard at the floor rearward of the vehicle as shown in the figure below.
NOTE: Standard tape width is about 30 - 50 mm (1.18 - 1.97 in) and brilliant color shall be used.

Fig 1: Identifying Vehicle Body Center Line
Courtesy of SUBARU OF AMERICA, INC.
Confirm the following before checking the corresponding items.
1. Rearview camera image is not displayed. (Audio and navigation screens are displayed normally.)
  1. Check the condition of back sensor connection.
    - Audio model: <Ref. to CHECK EACH CONNECTION , INSPECTION, Audio System.>
    - Navigation model: <Ref. to CHECK EACH CONNECTION , INSPECTION, Navigation System.>
  2. Check the condition of rearview camera connection.
    - Audio model: <Ref. to CHECK EACH VEHICLE SIGNAL , INSPECTION, Audio System.>
    - Navigation model: <Ref. to CHECK EACH VEHICLE SIGNAL , INSPECTION, Navigation System.>
2. Marker position is not aligned.
  Adjust the marker position according to the MARKER ADJUSTMENT MODE. <Ref. to MARKER ADJUSTMENT MODE , ADJUSTMENT, Rearview Camera System.>