General Tool

WARNING: This page is about a different car, the 2015 Subaru Outback and 2015 Subaru Legacy. However, it is still accessible from the selected car via links, so may be relevant.

TOOL NAME	REMARKS
Circuit tester	Used for measuring voltage and resistance.

NOTE: Referring to the data described below, prepare the materials to make a nozzle - windshield washer adjustment tool.

Fig 1: Identifying Windshield Washer Adjustment Tool Dimension

Courtesy of SUBARU OF AMERICA, INC.

Materials

Vertebra of wiper blade which is to be discarded
Vinyl tape

Steps of making a front washer nozzle adjustment tool

Fig 2: Identifying Front Washer Nozzle Adjustment Tool Dimension

Courtesy of SUBARU OF AMERICA, INC.

Bend the vertebra at the position 25 mm (0.98 in) away from its end by 45°.
Bend the vertebra at the position 29 mm (1.14 in) away from the other end by 45°.
Double up the vertebra so that the longer end (29 mm (1.14 in)) comes upward.
Secure the vertebra with a vise (a) so that the tip clearance becomes 5 mm (0.20 in).
Bend the vertebra at the position approximately 90 mm (3.54 in) away from the bending point for the longer end.
Check that the tip clearance is 5 mm (0.20 in), and secure the vertebra with vinyl tape (b).