Primary Speed Sensor: Removal

WARNING: This page is about a different variant/trim than selected.

CAUTION: Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.

Disconnect the ground terminal from battery sensor. <Ref. to BATTERY , NOTE, Note.>
Remove the intercooler. <Ref. to REMOVAL , Intercooler.>
Clean the transmission exterior.
Remove the primary speed sensor harness connector.

Fig 1: Identifying Primary Pressure Sensor Harness Connector
Courtesy of SUBARU OF AMERICA, INC.
Remove the primary speed sensor and the spacer.

Fig 2: Locating Primary Speed Sensor And Spacer Bolt
Courtesy of SUBARU OF AMERICA, INC.