LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2016 >> WRX Base >> Repair and Diagnosis >> Restraints >> Air Bag, SRS >> Air Bag System >> Airbag Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Airbag Control Module: Removal

CAUTION:
  • Refer to "CAUTION" of "General Description" before handling the airbag system components. < Ref. to CAUTION , General Description. >
  • Do not disassemble the airbag control module.
  • If the airbag control module is deformed or if there is any trace of water on the module, replace the airbag control module with a new one.
  • Do not drop the airbag control module.
  • After removal, keep the airbag control module on a dry, clean surface away from moisture, heat and dust.
  1. Turn the ignition switch to OFF.
  2. Disconnect the ground cable from battery and wait for at least 60 seconds before starting work. < Ref. to BATTERY , NOTE, Note. >
    NOTE:
    • For models other than STI model, disconnect the ground terminal from battery sensor.
    • On CVT models, shift the select lever into "D" before disconnecting the battery ground cable.
  3. Remove the console box assembly and the cover - shift lever. < Ref. to REMOVAL , Console Box. >
  4. Remove the center grille assembly. < Ref. to REMOVAL , Air Vent Grille. >
  5. Remove the audio assembly or navigation assembly. < Ref. to REMOVAL , Audio. >
  6. Remove the airbag control module.
    1. Disconnect the connector from airbag control module. < Ref. to AIRBAG CONTROL MODULE , PROCEDURE, Airbag Connector. >
    2. Remove the bolt and nuts and remove the airbag control module.
      Fig 1: Disconnecting Connector From Airbag Control Module
      G08316384Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals