Secondary Pressure Sensor: Inspection
WARNING: This page is about a different variant/trim than selected.
- Start and warm up the engine.
- Depress the brake pedal, and shift the select lever to "D" range.
- Shift the select lever to "P" or "N" range.
- Depress the brake pedal and hold it.
- Check «secondary pressure sensor voltage» by using Subaru Select Monitor while the engine is idling. Ref. to
OPERATION
, Subaru Select Monitor.
Standard
Approx. 0.8 V
- Check «secondary pressure sensor voltage» by using Subaru Select Monitor while the engine is stopped and the ignition switch is turned on. Ref. to
OPERATION
, Subaru Select Monitor.
Specification:
Approx. 0.5 V