VDC Sequence Control With SUBARU Select Monitor

CAUTION: For models with EyeSight, performing the sequence control may cause the EyeSight warning light to illuminate. If the sequence control is performed, refer to "Basic Diagnostic Procedure" of "EyeSight (DIAGNOSTICS)" and check DTCs and then clear memory. Ref. to EyeSight (DIAGNOSTICS)>Basic Diagnostic Procedure .

NOTE: In the event of any trouble, sequence control will not operate.

Connect the Subaru Select Monitor.
NOTE: For detailed operation procedures, refer to "Application help".
1. Turn the ignition switch to ON.
2. On [Start] display, select [Diagnosis].
3. On [Vehicle selection] display, input the target vehicle information and select [OK].
4. On [Main Menu] display, select [Each System].
5. On [Select System] display, select [Brake Control System], and then select [Enter].
6. On [Select Function] display, select [Work Support].
7. On the work support item list, select [VDC Function Check Mode].
Operate according to the procedures displayed in the Subaru Select Monitor.
The brake system being operated is displayed on the Subaru Select Monitor.