Primary Speed Sensor: Installation

CAUTION: Be sure to prevent water or oil from contacting the connector terminal of primary speed sensor. If adhesion occurs, replace with a new part.

Install the primary speed sensor.
NOTE:
- Use new O-rings.
- Apply CVTF to the O-rings.
Tightening torque:

5 N.m (0.5 kgf-m, 3.7 ft-lb)
Connect the harness connector.
Install the harness stay.
Tightening torque:

16 N.m (1.6 kgf-m, 11.8 ft-lb)
Install the air intake boot. Ref. to INSTALLATION , Air Intake Boot.
Connect the ground terminal to battery sensor. Ref. to BATTERY
NOTE: Repair Contents.
Install the collector cover.