Section 16 (Engine Starting System & Charging System): Starter: Installation

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

Install the starter together with the cable stay (A).
Tightening torque:

50 N.m (5.1 kgf-m, 36.9 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Connect the connector (A) and terminal B (B).
Tightening torque:

11 N.m (1.1 kgf-m, 8.1 ft-lb)
Connect the ground terminal (C).
Tightening torque:

14 N.m (1.4 kgf-m, 10.3 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the nut or bolt on the lower side of the starter.
Tightening torque:

50 N.m (5.1 kgf-m, 36.9 ft-lb)
- CVT model
Courtesy of SUBARU OF AMERICA, INC.
- MT model
Courtesy of SUBARU OF AMERICA, INC.
Install the CVTF cooler pipe. (Model with CVTF cooler (air cool))
Tightening torque:

16 N.m (1.6 kgf-m, 11.8 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the center exhaust pipe (rear). Ref. to EXHAUST (H4DOTC)>CENTER EXHAUST PIPE>INSTALLATION>CENTER EXHAUST PIPE (REAR) .
Install the intercooler. Ref. to INTAKE (INDUCTION) (H4DOTC)>INTERCOOLER>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NO: TE>BATTERY .