LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2017 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Anti-Theft System - Security And Locks) >> Front Hood Lock Assembly >> Installation >> Hood Lock Assembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Hood Lock Assembly

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Before installation, check the following items.
    • The cable is free from deformation.
    • Grease is applied sufficiently to cable joints.

      If grease is insufficient, add it as necessary before assembling the cable.

  2. Install the cable assembly front hood.
  3. Adjust and install the lock assembly front hood.
    NOTE:

    Refer to "ADJUSTMENT" of the lock assembly front hood. Ref. to  SECURITY AND LOCKS>FRONT HOOD LOCK ASSEMBLY>ADJUSTMENT  

    1. Install the lock assembly front hood with nuts and clips.

      Tightening torque: 

      33 N.m (3.4 kgf-m, 24.3 ft-lb)

    2. Install the connectors, connector clips, and harness clips.
  4. Install the bumper face front. Ref. to EXTERIOR/INTERIOR TRIM>FRONT BUMPER>INSTALLATION
  5. Install the cover UPR front.
  6. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>AIR INTAKE DUCT>INSTALLATION
  7. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY
  8. Check the clearance and surface level gap between hood COMPL front and bumper face front, and adjust if it is outside the standard value. Ref. to EXTERIOR BODY PANELS>FRONT HOOD>ADJUSTMENT
scientia non olet · About LEMON Manuals