Destination Setting

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

For the vehicle requiring the destination setting, if the destination setting is not finished, display cannot be shifted into customizing screen.

CONFIRM CURRENT SETTING .
Always perform confirmation of current setting before replacing the module.

Record the contents of the "Destination Setting".

NOTE:
Refer to Read Data Monitor and Confirm Current Setting to confirm the current setting. Ref. to BODY CONTROL (DIAGNOSTICS)>DATA MONITOR

Is the current setting recorded?

Yes : Go to 2.

No : Confirm the current setting. Go to 1.
CONFIRM DESTINATION SETTING .
1. Connect the Subaru Select Monitor, and run the application.
2. On [Start] screen, select [Diagnosis].
3. On [Vehicle selection] screen, input the target vehicle information and select [OK].
4. On [Main Menu] screen, select [Each System].
5. On [Select System] screen, select [Body Control], and then select [Enter].
6. On [Select Function] screen, select [Customize].
7. The vehicle destination screen is displayed.
Is the vehicle destination setting screen displayed?

Yes : Go to 3.

No : Go to 4.
CONFIRM DESTINATION SETTING .
Confirm the screen displayed on Subaru Select Monitor and the actual vehicle destination.

Is it necessary to change the destination setting?

Yes : Select Yes, and Go to 4.

No : Select No, and Go to 5.
ENTER DESTINATION CODE .
Enter the appropriate code in the screen.

CAUTION:
Select the input value that corresponds to the set value (destination setting) saved in "1. CONFIRM CURRENT SETTING" before replacing the module.

JPN: JP00

KA, KC: KA00

KS: KS00

Europe LHD models except for KS: EC00

C0, C5: C000

U4, U5, U6: U400

EK, ER: EK00

Is the appropriate code entered?

Yes : Select "OK", and Go to 5.

No : Enter the appropriate code. Go to 5.
REGISTER VEHICLE EQUIPMENT .
Customizing screen is displayed.

NOTE:
Match the each item setting of body integrated unit registration item list with the vehicle equipment.

Do all setting contents match with the vehicle equipment specification?

Yes : Go to 6.

No : Change the items until each content setting match with the vehicle equipment specification. Go to 6.
CONFIRM MARKET MODE .
1. On the customizing screen, select the "Factory initial setting" to change the setting from "Factory mode" to "Market mode".
2. Turn the ignition switch to OFF.
  NOTE:
  When the setting is changed from "Factory" mode to "Market" mode, turning the ignition switch from ON → OFF confirms the setting.
3. Turn the ignition switch to ON, and check the contents of settings.
Is the mode changed to "Market" mode?

Yes : Go to 7.

No : Perform the destination setting from the first step. Go to 1.
CONFIRM MARKET MODE .
Check the following.

Make sure that the "Destination Setting" in the data monitor is the same as the one you confirmed in step 1.

Is the display the same as indicated?

Yes : Registration of body integrated unit is finished.

No : It is possible that harness malfunction may occur. Perform the diagnosis.