Steering Sensor: Installation
WARNING:
The following service operations include the works which may affect the SRS airbag system. Before starting work, always check the precautions for the SRS airbag system. (Refer to
SRS AIRBAG SYSTEM
)
- Installation of steering sensor
- Apply grease to the protruding part of the inner periphery of the steering sensor.
- Align 2 pins and 2 guides.
- Engage 6 claws, and then attach the steering sensor to the steering roll connector.CAUTION: Do not rotate the steering sensor until the steering sensor is attached to the spiral cable.
- Installation of steering roll connector SUB-ASSY (with steering sensor) (Refer to INSTALLATION )
- Installation of the steering column cover UPR (Refer to INSTALLATION )
- Installation of the steering column cover LWR (Refer to INSTALLATION )
- Installation of steering column cover support (with smart entry)
- +Confirmation of front tires in the straight-ahead position
- Steering roll connector centering (Refer to INSTALLATION )
- Installation of steering wheel (Refer to INSTALLATION )
- Connection of the battery ground terminal
Standard value: T=6.0N.m {61kgf.cm} {4.4ft.lbf}
- Settings when removing/installing battery terminals (Refer to SETTING PROCEDURES AT PARTS REPLACEMENT AND REMOVAL/INSTALLATION )
- VDC sensor mid point setting (Refer to WORK SUPPORT )
- Inspection of airbag warning light (Refer to AIRBAG WARNING LIGHT ILLUMINATION PATTERN )