Starting System & Charging System: Starter: Installation
- Install the starter and cable stay.NOTE: For the MT model, a bolt is used in the lower side of the starter.
Tightening torque:
50 N.m (5.1kgf-m, 36.9ft-lb)
- Connect the connector, terminal B and ground terminal.
Tightening torque:
Terminal B
11 N.m (1.1kgf-m, 8.1ft-lb)
Ground terminal
14 N.m (1.4kgf-m, 10.3ft-lb)
- Install the front wheel LH. Ref. to WHEEL AND TIRE SYSTEM>Tire and Wheel>INSTALLATION .
- Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO)>Air Intake Boot>INSTALLATION .
- Connect the battery ground terminal. Ref. to REPAIR CONTENTS>NOTE>BATTERY .