CROSSTREK Model
CAUTION:
For parts which are not reusable, always use new parts.
- Install the ball joint into the housing - front axle.CAUTION:
- Do not apply grease to the tapered portion of ball stud.
- Be careful not to damage the boot of the joint.
- Before tightening, make sure the bottom surface of the housing - front axle and the stepped section of ball joint are in contact.
Tightening torque:
50 N.m (5.1kgf-m, 36.9ft-lb)
- Install the ball joint into the front arm assembly.
- Connect the ball joint to the front arm assembly.
Tightening torque:
39 N.m (3.98kgf-m, 28.8ft-lb)
- Retighten the castle nut further within 60° until the hole in the ball stud is aligned with a slot in the castle nut.
- Insert a new cotter pin and bend it around the castle nut.
- Connect the ball joint to the front arm assembly.
- Install the crossmember support - rear.
Tightening torque:
70 N.m (7.1kgf-m, 51.6ft-lb)
- Install the under cover - front.
Tightening torque:
18 N.m (1.8kgf-m, 13.3ft-lb)
- Lower the vehicle, and install the front wheels.
Tightening torque:
120 N.m (12.2kgf-m, 88.5ft-lb)