LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> Outback 2.5i >> Repair and Diagnosis (Single Page) >> Body & Frame >> Exterior Body Panels >> Power Rear Gate System >> Power Rear Gate Control Module >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Power Rear Gate Control Module: Removal

  1. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  2. Remove the trim panel - rear apron LH. Ref. to EXTERIOR/INTERIOR TRIM>Rear Quarter Trim>REMOVAL .
  3. Remove the power rear gate control module (PRG CONTROL MODULE).
    1. Disconnect the connectors in the following order.
      1. Disconnect the connector (b).
      2. Pull the slide lock in the arrowed direction, and disconnect the connector (a) by pressing in the lock.
      3. Disconnect the connector (c).
        NOTE: When the connectors are not disconnected in the sequence, a diagnosis code (DTC) may be detected.
        G10309971Courtesy of SUBARU OF AMERICA, INC.
    2. Release the lock and hook, and remove the power rear gate control module (PRG CONTROL MODULE).
      G10309972Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals