Check With SUBARU Select Monitor

Connect the Subaru Select Monitor.
NOTE: For detailed operation procedures, refer to "Application help".
1. On <<Start>> display, select <<Diagnosis>>.
2. On <<Vehicle selection>> display, input the target vehicle information and select <<Confirmed>>.
3. On <<Main Menu>> display, select <<Each System>>.
4. On <<Select System>> display, select <<Brake Control System>> and select <<Enter>>.
5. On <<Select Function>> display, select <<Data Monitor>>.
6. From the data monitor item list, select <<FR Wheel Speed>> and <<FL Wheel Speed>>.
Check if the speed indicated on the display changes in the same manner as the speedometer reading during acceleration/deceleration when the steering wheel is in the straight-ahead position.
If the inspection result shows that the value for either side alone does not change on the display screen, swap the ABS wheel speed sensors between LH and RH and then check again to see if the value changes or not.
NOTE: Using a tape or the like, mark the one on which the value did not change.
- If the inspection result shows that the value does not change on the sensor marked: Replace the relevant ABS wheel speed sensor.
- If the inspection result shows that the value does not change on the sensor not marked: Place the ABS wheel speed sensor that is not marked to the original position, and perform unit inspection on the ABS wheel speed sensor that is marked. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>Front ABS Wheel Speed Sensor>INSPECTION>CHECK ABS WHEEL SPEED SENSOR UNIT .