LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2018 >> WRX Base >> Repair and Diagnosis (Single Page) >> Brakes >> Anti-Lock Brakes >> Vehicle Dynamics Control System >> Auto Vehicle Hold Switch >> Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Auto Vehicle Hold Switch: Inspection

  1. Measure the resistance between connector terminals.

    Preparation tool:

    Circuit tester

    G10297699
    1. Measure the resistance between auto vehicle hold switch terminals.
      TERMINAL NO. INSPECTION CONDITIONS STANDARD
      1 - 4 Switch OFF 1 MΩ or more
      Switch ON Less than 1 Ω
    2. Apply battery voltage between the connector terminals to check lighting condition of illumination inside the switch.
      TERMINAL NO. INSPECTION CONDITIONS SPECIFICATION
      2 (+) - 3 (-) Apply Battery Voltage. Light ON
  2. Replace the auto vehicle hold switch if the inspection result is not within the standard value.
scientia non olet · About LEMON Manuals