Combination Switch (Light): Installation
CAUTION:
- Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
- Do not allow harness and connectors to interfere or get tangled up with other parts.
- If the steering wheel has been removed, make sure that the steering roll connector is not turned from the original position.
- If the steering wheel and steering angle sensor (steering roll connector) are removed, perform "VSC(VDC) Centering Mode" of the VDC. Refer to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
- Install the switch assembly combination turn dimmer.
- Using pliers, loosen the clamp.
- With the clamp loosened, insert so that the cutout of the column assembly steering and the claw of the switch assembly combination turn dimmer are aligned, and then engage them.
- Install the clamp, and connect the connector.NOTE: When replacing with a new part, engage the claw first, and then pull out the securing pin of the clamp.
- Install the switch assembly combination wiper. Refer to WIPER AND WASHER SYSTEMS>Combination Switch (Wiper)>INSTALLATION .
- Install the steering roll connector. Refer to AIRBAG SYSTEM>Roll Connector>INSTALLATION .
- Install the column cover assembly. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Column>INSTALLATION .
- Install the steering wheel. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>INSTALLATION .
- Install the driver's airbag module. Refer to AIRBAG SYSTEM>Driver's Airbag Module>INSTALLATION .
- Install the cover LWR driver. Refer to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .