LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2020 >> Outback Base >> Repair and Diagnosis >> Accessories & Equipment >> Headlights >> Lighting System >> Combination Switch (Light) >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Combination Switch (Light): Removal

CAUTION: Before handling the airbag system components, refer to AIRBAG SYSTEM>General Description>CAUTION .
  1. Set the tire to the straight-ahead position.
  2. Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Refer to REPAIR CONTENTS>NOTE>BATTERY .
  3. Remove the cover LWR driver. Refer to EXTERIOR/INTERIOR TRIM>Instrument Panel Lower Cover>REMOVAL .
  4. Remove the driver's airbag module. Refer to AIRBAG SYSTEM>Driver's Airbag Module>REMOVAL .
  5. Remove the steering wheel. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Wheel>REMOVAL .
  6. Remove the column cover assembly. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>Steering Column>REMOVAL .
  7. Remove the steering roll connector. Refer to AIRBAG SYSTEM>Roll Connector>REMOVAL .
  8. Remove the switch assembly combination wiper. Refer to WIPER AND WASHER SYSTEMS>Combination Switch (Wiper)>REMOVAL .
  9. Remove the switch assembly combination turn dimmer.
    1. Disconnect the connector.
    2. Using pliers, loosen the clamp.
    3. With the clamp loosened, release the claw using a flat tip screwdriver wrapped with protective tape, and remove the switch assembly combination turn dimmer.
      CAUTION: Do not pry off forcibly. Otherwise, the claws may be damaged.
G11245594Courtesy of SUBARU OF AMERICA, INC.
scientia non olet · About LEMON Manuals