Lighting System: General Description: Caution

When performing service operation, refer to REPAIR CONTENTS>REPAIR CONTENTS .
Before disconnecting connectors of sensors or units, be sure to disconnect the ground terminal from the battery sensor. When replacing the parts provided with memory functions, record the memory contents before disconnecting the ground terminal from the battery sensor.
Be careful of the following items. Failing to do so may cause the airbag system malfunction.
- Yellow connectors and harnesses with yellow tapes around them are the connectors and harnesses for the airbag system. When using a tester on these circuits, refer to AIRBAG SYSTEM>General Description>CAUTION .
- Be careful not to damage the airbag system wiring harness when servicing the electrical parts around the steering column.
When removing, installing or replacing the VDC Control Module &H/U, VDC Control Module &H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform "VSC(VDC) Centering Mode" of the VDC. Refer to VEHICLE DYNAMICS CONTROL (VDC)>VDC Control Module and Hydraulic Control Unit (VDCCM&H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
Use a dry clean cloth so that no grease or water adheres to the glass portion of the bulb.
Always replace with a bulb that is the same model and wattage as those of the old one.