Front Seat: Installation
- Bring the front seat inside the vehicle.
- Connect the connectors located under the front seat.
- Install the seat assembly.CAUTION:
- Tighten the slide rail assembly installing bolts in the order as shown in the figure, in several steps by gradually increasing the torque until they reach the specified torque.
- Before installing the bolt cover, check the cover inside. If deformed or damaged, replace the bolt cover with a new one.
Incorrect installation of the bolt cover may result in detachment while driving the vehicle.
Tightening torque:
53 N.m (5.4 kgf-m, 39.1 ft-lb)
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
- Install the headrest assembly.
- Perform [Rezeroing] for the occupant detection system. Refer to AIRBAG (DIAGNOSTICS)>Rezero .
- For model with door mirror interlocked seat position memory, initialize the ECM seat memory. Refer to SEATS>Power Seat System>ADJUSTMENT .