July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Oil Control Solenoid: Installation: Intake

WARNING: This page is about a different variant/trim than selected.

RH SIDE
1. Install the backup ring to the oil control solenoid.
2. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
3. Connect the connector.
4. Install the air intake duct. Refer to INTAKE (INDUCTION) (H4DO)>Air Intake Duct>INSTALLATION .
5. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
LH SIDE
1. Install the backup ring to the oil control solenoid.
2. Using a new O-ring, install the oil control solenoid.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
3. Connect the connector.
4. Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .