Steering Column: Installation

CAUTION:

When removing, installing or replacing the VDCCM & H/U, VDCCM & H/U bracket, steering wheel or steering angle sensor (steering roll connector), perform "VSC(VDC) Centering Mode" of the VDC. Ref. to VEHICLE DYNAMICS CONTROL (VDC)>VDC CONTROL MODULE AND HYDRAULIC CONTROL UNIT (VDCCM & H/U)>ADJUSTMENT>VDC SENSOR MIDPOINT SETTING MODE .
Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

Install the bushing (a) to the toe board from the passenger compartment side.

Courtesy of SUBARU OF AMERICA, INC.
Insert the end of the column assembly - steering into the toe board bushing.
Tighten the column assembly - steering installation nut located under the beam COMPL - steering with the tilt lever fixed.
Tightening torque: 20 N.m (2 kgf-m, 14.8 ft-lb)
Install the ignition key lock. (Models without the keyless access with push button start system) Ref. to SECURITY AND LOCKS>IGNITION KEY LOCK>REPLACEMENT .
Install the steering lock control module. (Models equipped with the keyless access with push button start system) Ref. to SECURITY AND LOCKS>STEERING LOCK CONTROL MODULE>REPLACEMENT .
Install the switch assembly - combination.
Connect all the connectors under the instrument panel.
Install the universal joint assembly - steering. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>UNIVERSAL JOINT>INSTALLATION .
CAUTION:
- Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
- Be sure to follow the tightening order and tightening torque of the universal joint assembly - steering to avoid the steering effort from becoming heavy.
  After confirming that the steering column position is in the neutral position, tighten the universal joint assembly - steering.
- Always place the tilt lever to the lock position after the steering column is adjusted.
Install the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
Install the cover assembly - instrument panel LWR driver.
Install the cover assembly - column.
Align the center position of the steering roll connector. Ref. to AIRBAG SYSTEM>ROLL CONNECTOR>ADJUSTMENT .
Install the steering wheel.
Tightening torque: Steering wheel: 39 N.m (4 kgf-m, 28.8 ft-lb)

Clearance: Between cover assembly - column and steering wheel: 4 - 6 mm (0.16 - 0.24 in)
Install the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
NOTE: For the hybrid model, connect the battery negative terminal.