April 5, 2026: LEMON Manuals is launched! Read the announcement.

DTC B2D00: Camera Ecu Internal Failure

DTC detecting condition:

When an internal malfunction occurs in the camera control module.

Trouble symptom:

The screen does not change.

CAUTION: Before performing diagnosis, refer to "CAUTION" in "General Description". Ref. to MULTI VIEW MONITOR (DIAGNOSTICS)>General Description>CAUTION .

CHECK DTC .
1. Turn the ignition switch to ON.
2. Using the Subaru Select Monitor, perform the clear memory of [Multi View Monitor] Ref. to COMMON (DIAG)>CLEAR MEMORY .
3. Read the DTC of [Multi View Monitor] using the Subaru Select Monitor Ref. to MULTI VIEW MONITOR (DIAGNOSTICS)>DIAGNOSTIC TROUBLE CODE (DTC) .
  Is DTC B2D00 displayed? (Current malfunction)
  
  Yes : Replace the camera control module. Ref. to ENTERTAINMENT & MONITORING>CONTROL UNIT .
  
  No : Even if DTC is displayed, the circuit has returned to a normal condition at this time. Reproduce the failure, and then perform the diagnosis again.
  
  NOTE: In this case, temporary poor contact of connector, temporary open or short circuit of harness may be the cause.