Section 6 (Exhaust System (2.4L)): Muffler: Installation

WARNING: This page is about a different variant/trim than selected.

Install the rear exhaust cover.
Tightening torque:

10 N.m (1.0 kgf-m, 7.4 ft-lb)
Apply a coat of spray type lubricant to the mating area of cushion rubber, and install the muffler.
NOTE: After installation, degrease the cushion rubber.
Using a new gasket, connect the rear exhaust pipe and muffler.
CAUTION: Be sure to use a new self-locking nut.

Tightening torque:

48 N.m (4.9 kgf-m, 35.4 ft-lb)