Section 17 (Brake System): General Description: Preparation Tool: Other
WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
| REMARKS | |
|---|---|
| Wobble extension | Used for installing the brake booster. |
| Crowfoot wrench | Used for installing the brake pipe.
NOTE:
Use Snap-on FRHM10 or FRHM12, or another manufacturer's 12-point wrench. |
| Circuit tester | Used for measuring resistance, voltage and current. |
| Dial gauge | Used for measuring brake disc run-out. |
| Magnet stand | Used for measuring brake disc run-out. |
| Micrometer | Used for measuring the brake disc thickness. |
| Disc brake piston tool | Used for pushing back the electronic parking brake piston.
|
| Disc brake piston tool | Used for pushing back the piston. (Except for electronic parking brake) |
| Vacuum gauge | Used for measuring the operation and airtightness of the brake booster. |
| Flare nut wrench | Used for removing and installing the brake pipe. |
| Pressure gauge | Used for measuring the operation and airtightness of the brake booster. |
| Brake fluid caution label (Part No. 25080GA010) | Used when the reservoir tank is replaced.
NOTE:
This is the SUBARU genuine part. |
| Pedal force gauge | Used for measuring the operation and airtightness of the brake booster. |
| Hexagon wrench | Used for removing and installing the electronic parking brake caliper. Width across flat 7 mm (0.28 in) |
| PLUG BOLT (Part No. 26642AL000) | Used for preventing the brake fluid leakage or the air entry inside the caliper when disconnecting the brake hose from the electronic parking brake caliper.
NOTE:
This is the SUBARU genuine part. |
| PLUG GASKET (Part No. 26642AL010) |
Used for preventing the brake fluid leakage or the air entry inside the caliper when disconnecting the brake hose from the electronic parking brake caliper.
NOTE:
This is the SUBARU genuine part. |