LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2021 >> WRX Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Anti-Theft System - Security And Locks) >> Key Lock Cylinders >> Replacement >> Front Door
July 1: So it begins. Don't worry, this is not in the correct legal jurisdiction!

Front Door

WARNING: This page is about a different car, the 2022 Subaru WRX. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise the glass assembly front door to the top position.
  2. Remove the cover handle front outer.
    1. Remove the plug at the rear end of the panel assembly front door.
      G11246295Courtesy of SUBARU OF AMERICA, INC.
    2. Using TORX® T30, loosen the bolt and remove the cover handle front outer.
      G13226871Courtesy of SUBARU OF AMERICA, INC.
  3. Replace the key cylinder.
    1. Release the claws.
    2. Remove the key cylinder (b) from the cover handle front outer (a), and replace the key cylinder.
      G11246363Courtesy of SUBARU OF AMERICA, INC.
  4. Using TORX® T30, install the cover handle front outer.
    NOTE:

    When installing the outer handle cover on the driver's side, make sure that the key cylinder shaft is correctly inserted into the latch & actuator assembly front. 

    Tightening torque: 

    7.5 N.m (0.8 kgf-m, 5.5 ft-lb)

  5. Install the plugs.
scientia non olet · About LEMON Manuals