Camshaft Position Sensor: Installation: Intake

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

RH SIDE
1. Install the camshaft position sensor with new O-ring.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
2. Connect the connector.
3. Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>Air Intake Duct>INSTALLATION .
4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
LH SIDE
1. Install the camshaft position sensor with new O-ring.
  NOTE: Apply engine oil to O-ring.
  
  Tightening torque:
  
  6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
2. Connect the connector.
3. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .