LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> Ascent Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Fuel Injection System) >> Engine Wiring Harness >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Engine Wiring Harness: Installation

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
  1. Set the engine wiring harness to the engine, and connect each connector. Ref. to FUEL INJECTION (FUEL SYSTEM) (H4DOTC)>General Description>COMPONENT>ENGINE WIRING HARNESS .
    NOTE:
    • If the clip is damaged, replace it with a new part.
    • Before replacing the clip, put an alignment mark (a) on both engine wiring harness and clip to remove the clip, and then align to the alignment mark (a) to attach a new clip to the engine wiring harness.
    G13198268Courtesy of SUBARU OF AMERICA, INC.
  2. Install the fuel insulator. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Fuel Insulator>INSTALLATION .
  3. Install the intake manifold assembly. Ref. to FUEL INJECTION (FUEL SYSTEMS) (H4DOTC)>Intake Manifold Assembly>INSTALLATION .
  4. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals