Oil Control Solenoid: Installation: Intake
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
- RH SIDE
- Install the backup ring to the oil control solenoid.
- Using a new O-ring, install the oil control solenoid.NOTE: Apply engine oil to O-ring.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Connect the connector.
- Install the air intake duct. Ref. to INTAKE (INDUCTION) (H4DOTC)>Air Intake Duct>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
- LH SIDE
- Install the backup ring to the oil control solenoid.
- Using a new O-ring, install the oil control solenoid.NOTE: Apply engine oil to O-ring.
Tightening torque:
6.4 N.m (0.7 kgf-m, 4.7 ft-lb)
- Connect the connector.
- Hold the engine wiring harness with the clip.
- Install the reservoir tank. Ref. to COOLING (H4DOTC)>Reservoir Tank>INSTALLATION .
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .