Secondary Pressure Sensor: Installation
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
If water or oil contacts the connector terminal of secondary pressure sensor, replace it with a new part.
- Install a new O-ring.NOTE: Apply CVTF to the O-rings.
- Using Ko-ken 3/8 12-point 27-mm deep socket (part No. 3305M-27), install the secondary pressure sensor and connect the connector.
Tightening torque:
39 N.m (4.0 kgf-m, 28.8 ft-lb)
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .