LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2022 >> Ascent Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 19 (Lighting System) >> High-mounted Stop Light >> Installation
April 5, 2026: LEMON Manuals is launched! Read the announcement.

High-mounted Stop Light: Installation

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: Make sure the bolt is tightened securely because improper installation of the spoiler assembly roof may cause water leakage.
  1. Install the stop light assembly high-mounted.

    Tightening torque: 

    4.5 N.m (0.5 kgf.m, 3.3 ft.lb)

  2. Install the spoiler assembly roof, Ref. to EXTERIOR/INTERIOR TRIM>Roof Spoiler>INSTALLATION .

    Tightening torque: 

    7.5 N.m (0.8 kgf.m, 5.5 ft.lb)

  3. Install the sensor touch assembly. (Model with power rear gate) Ref. to POWER REAR GATE SYSTEM>Power Rear Gate Touch Sensor>INSTALLATION .
  4. Install the drip rear gate. (Model without power rear gate)
  5. Install the trim panel assembly rear gate, Ref. to EXTERIOR/INTERIOR TRIM>Rear Gate Trim>INSTALLATION .
  6. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
scientia non olet · About LEMON Manuals