Rear Lock Button: Installation
WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Make sure that the harness grommet is securely installed
.
If not properly installed, this may cause leaks .
If not properly installed, this may cause leaks .
- Install the switch request (lock).
- Install the switch opener rear gate, Ref. to SECURITY AND LOCKS>Rear Gate Opener Button>INSTALLATION .
- Install the garnish assembly rear gate.
Tightening torque:
4.5 N.m (0.5 kgf.m, 3.3 ft.lb)
- Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .