Select Cable: Removal

WARNING: This page is about a different car, the 2021 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the ground terminal from battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Release the shift lock using a screwdriver, etc. and shift the select lever to the "N range".

Courtesy of SUBARU OF AMERICA, INC.
Remove the center exhaust cover (front). Ref. to EXHAUST (H4DOTC)>Rear Exhaust Pipe>REMOVAL .
Disconnect the select cable from the transmission main body.
CAUTION: Do not apply excessive load while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Remove the adjusting nut (rear).

Courtesy of SUBARU OF AMERICA, INC.
Raise the claw of clamp and remove the select cable together with the clamp.
CAUTION: Do not apply excessive load while holding the part (a).

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Remove the clamp from the select cable.
Remove the cable plate.

Courtesy of SUBARU OF AMERICA, INC.