Transmission Control Module (TCM): Installation

WARNING: This page is about a different car, the 2022 Subaru Impreza. However, it is still accessible from the selected car via links, so may be relevant.

Attach the TCM.
Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Attach the harness connector to the TCM.
NOTE:
Move the lock lever in the arrow direction, and confirm that a clicking sound is heard.

Courtesy of SUBARU OF AMERICA, INC.
Insert the transmission case cover (small) between transmission case cover (large) and transmission to install.
CAUTION:
When inserting, be careful that the insulator inside transmission case cover is not turned over.

Tightening torque:

7 N.m (0.7 kgf-m, 5.2 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.

Courtesy of SUBARU OF AMERICA, INC.
Install the pitching stopper.
Tightening torque:

T1: 50 N.m (5.1 kgf-m, 36.9 ft-lb)

T2: 58 N.m (5.9 kgf-m, 42.8 ft-lb)

Fig 1: Pitching Stopper Nuts And Bolts (With Torque Specification)
Courtesy of SUBARU OF AMERICA, INC.
Install the air breather hose and air breather hose bracket.

Courtesy of SUBARU OF AMERICA, INC.
Connect the transmission radio ground terminal.
Tightening torque:

32.3 N.m (3.3 kgf-m, 23.8 ft-lb)

Courtesy of SUBARU OF AMERICA, INC.
Install the air intake boot. Ref. to INTAKE (INDUCTION) (H4DO (EXCEPT FOR HEV))>AIR INTAKE BOOT>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>REPAIR CONTENTS>NOTE>BATTERY .
Using the Subaru Select Monitor, perform «Clear AT learning value» on «Work Support», and perform the operation of AT learning mode. Ref. to TRANSMISSION (DIAGNOSTICS) (IMPREZA MODEL)>LEARNING CONTROL>PROCEDURE .