General Tool
WARNING: This page is about a different variant/trim than selected.
| TOOL NAME | REMARKS |
|---|---|
| Circuit tester | Used for measuring resistance, voltage and current. |
| Magnet stand | Used for measuring clutch disc run-out.
NOTE:
Used together with the dial gauge (spindle type).
|
| DIAL GAUGE (spindle type) | Used for measuring clutch disc run-out.
NOTE:
Used together with magnet stand.
|
| Depth gauge or caliper gauge | Used for measuring the remaining amount of clutch disc. |
| Angle gauge | Used for installing the flywheel. |
| Crowfoot wrench (10 mm) | Used for installing the clutch pipe. |