Power Seat Control Module

Prior to starting work, check the following precautions. Ref. to SEATS>GENERAL DESCRIPTION>CAUTION .
When the seat position memory Control Module or the front seat equipped with the seat position memory Control Module with registered memory was replaced with a new part, perform the variant work. (Model with seat position memory) Ref. to POWER SEAT MEMORY(DIAGNOSTICS)>WORK SUPPORT>OPERATION
Raise the seat cushion by operating the switch.
Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Remove the driver's seat from the vehicle.
Remove the ECM seat memory.
1. Disconnect the connector.
2. Remove the nuts and remove the ECM seat memory.

Courtesy of SUBARU OF AMERICA, INC.