General Tool

TOOL NAME	REMARKS
Thickness gauge	Used for various inspections.
Spring scale	Used for measuring the initial load.
Crowbar	Used for removing the rear drive shaft.
Angle gauge	Used for angle tightening.
Dial gauge	Used for measuring backlash. (Spindle type) NOTE: Used together with magnet stand. Used for measuring the companion flange runout. (Lever type) NOTE: Used together with magnet stand.
Magnet stand	Used for measuring backlash. NOTE: Used together with the dial gauge (spindle type). Used for measuring the companion flange runout. NOTE: Used together with the dial gauge (lever type).