Fail Safe: List
If any of the following DTCs are stored, the system enters the fail safe mode.
| DTC | Failsafe operation | Failsafe deactivation condition |
|---|---|---|
| B2B00 | The driver's side power window does not operate. | AUTO SW signal ON → OFF |
| B2B01 | UP terminal input ON → OFF | |
| B2B02 | DOWN terminal input ON → OFF | |
| B2B03 | When the power window main switch is operated, driver's side window rolls down only in manual down operation, or inches up. (Inch up: Operating the switch rolls up the window about 10 mm only) | After 10 edges or more of UP direction pulses are detected consecutively in phase 1 and 2, initial setting of the power window is performed. Ref. to GLASS/WINDOWS/MIRRORS>POWER WINDOW SYSTEM>OPERATION . |
| B2B04 | ||
| B2B05 | ||
| B2B06 | ||
| B2B07 | Perform the initial setting of the power window. Ref. to GLASS/WINDOWS/MIRRORS>POWER WINDOW SYSTEM>OPERATION . | |
| B2B08 | ||
| B2B09 | When the power window main switch is operated, driver's side window does not work in automatic operation. | |
| B2B10 | When the power window main switch is operated, passenger's side window does not work. | AUTO SW signal ON → OFF |
| B2B11 | Power window remote switch signal UP → OFF | |
| B2B12 | Power window remote switch signal DOWN → OFF | |
| B2B20 | When the power window sub-switch is operated, passenger's side window does not work. | AUTO terminal input ON → OFF |
| B2B21 | UP terminal input ON → OFF | |
| B2B22 | DOWN terminal input ON → OFF | |
| B2B23 | When the power window sub-switch is operated, passenger's side window rolls down only in manual down operation, or inches up. (Inch up: Operating the switch rolls up the window about 10 mm only) | After 10 edges or more of UP direction pulses are detected consecutively in phase 1 and 2, initial setting of the power window is performed. Ref. to GLASS/WINDOWS/MIRRORS>POWER WINDOW SYSTEM>OPERATION . |
| B2B24 | ||
| B2B25 | ||
| B2B26 | ||
| B2B27 | Perform the initial setting of the power window. Ref. to GLASS/WINDOWS/MIRRORS>POWER WINDOW SYSTEM>OPERATION . | |
| B2B28 | ||
| B2B29 | When the power window main switch is operated, passenger's side window does not work in automatic operation. | |
| B2B50 | When input of the driver's side AUTO switch, passenger's side AUTO switch, passenger's side manual UP switch, or passenger's side manual DOWN switch continues for the prescribed length of time after input start, sending of the switch operation signal is stopped. | Input of the driver's side AUTO switch, passenger's side AUTO switch, passenger's side manual UP switch, or passenger's side manual DOWN switch turns ON → OFF. |