Section 9 (Engine Control System (2.5L) (Diagnostics) - Introduction)

• Basic Diagnostic Procedure
  • Procedure
• Check List for Interview
  • Check
    • Check List No. 1
    • Check List No. 2
• General Description
  • Caution
  • Inspection
    • Notes
    • Basic Inspection
    • Check Non-Permanent Occurrence Malfunctions
  • Note
  • Preparation Tool
    • SUBARU Special Tool
    • Other
    • How To Use Check Board
  • System Block Diagram
• Electrical Component Location
  • Location
    • Engine Unit
    • Body
    • Fuse And Relay
• Control Module I/O Signal
  • Electrical Specification
• Inspection Mode
  • Procedure
    • Notes
    • Inspection Mode 1
    • Inspection Mode A
    • Inspection Mode B
    • Inspection Mode H
    • Inspection Mode I
    • Inspection Mode J
    • Inspection Mode N
    • Inspection Mode O
    • Inspection Mode S
    • Inspection Mode T
    • Inspection Mode U
    • Inspection Mode V
    • Inspection Mode W
    • Inspection Mode X
    • Inspection Mode Y
    • Inspection Mode Z
    • Inspection Mode Aa
    • Inspection Mode Ac
    • Inspection Mode Ad
• Warning Light Illumination Pattern
  • Procedure
  • Activation Of Malfunction Indicator Light
  • Malfunction Indicator Light Does Not Come On
  • Malfunction Indicator Light Does Not Go Off
• Data Monitor
  • Operation
  • List
• Freeze Frame Data
  • Note
    • Freeze Frame Data
    • Time Series Freeze Frame Data
  • Operation
  • List
• Active Test
  • Operation
  • List
• Work Support
  • Operation
  • List
• All Readiness Diagnostic Code(s)
  • Operation
• Diagnostic Trouble Code (DTC)
  • Operation
  • List