LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Subaru >> 2024 >> WRX Base >> Repair and Diagnosis >> Transmission >> Automatic Trans >> CVT Transaxle System (Tr690) >> Front Reduction Driven Gear >> Disassembly
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Front Reduction Driven Gear: Disassembly

  1. Remove the front reduction driven shaft.
    G16389899Courtesy of SUBARU OF AMERICA, INC.
    (A)  Front reduction driven shaft 
    (B)  Front reduction driven gear 
  2. Remove the seal rings.
    G13622378Courtesy of SUBARU OF AMERICA, INC.
  3. Remove the ball bearing.
    1. Tap the ball bearing outer race to remove through the hole of front reduction driven shaft using the round bar with diameter of 7 mm (0.28 in).
      NOTE: Remove by tapping the entire circumference equally.
      G13200370Courtesy of SUBARU OF AMERICA, INC.
  4. Remove the snap ring, and then remove the retaining plate, drive plate, driven plate and dish plate.
    NOTE: In order to avoid installing the dish plate in the wrong direction, paint a mark before removal.
    G16389902Courtesy of SUBARU OF AMERICA, INC.
    (A)  Snap ring 
    (B)  Retaining plate 
    (C)  Drive plate 
    (D)  Driven plate 
    (E)  Dish plate 
    (F)  Front reduction driven gear 
scientia non olet · About LEMON Manuals