Fluid Level Set after Service
- Add transaxle fluid through the fill cap hole prior to adjusting the fluid level. The amount of fluid to add should be based on the type of service done.NOTE:
- Use ESSO LT 71141 or TOTAL ATF H50235 transaxle fluid only.
- Oil pan removed: 4 L (4.2 qt)
- Torque converter removed: 2 L (2.1 qt)
- Complete overhaul: 7.4 ± 0.2 L (7.8 ± 0.2 qt)
- Drain plug removed: 4 L (4.2 qt)
- Check the transaxle fluid level. Refer to Transaxle Fluid Level Check .
- Add additional fluid through the fill cap hole in 0.5 liter (0.5 quart) increments until the fluid comes out through the plug hole.
- Allow the fluid to finish draining out through the plug hole, then install the fluid level plug.
- When the fluid level setting procedure is completed, wipe any fluid from the transaxle case with a rag or shop towel. Also, check that the fluid fill cap and the vent tube are properly installed.