Module - Body Controller - Front (Dual Motor) - Remove and Replace: Remove
- Remove the 2nd row lower seat cushion. See SEAT CUSHION - LOWER - 2ND ROW (REMOVE AND REPLACE) .
- Remove the rear underhood apron. See UNDERHOOD APRON - REAR (REMOVE AND REPLACE) .
- Remove the cabin intake duct. See DUCT - CABIN INTAKE (REMOVE AND REPLACE) .
- Remove the underhood storage unit. See UNDERHOOD STORAGE UNIT (REMOVE AND REPLACE) .
- Remove the LH and RH wiper arms. See WIPER ARMS (REMOVE AND REPLACE) .
- Remove the LH and RH shock tower covers. See COVER - SHOCK TOWER - LH (REMOVE AND REPLACE) .
- Remove the cowl screen panel. See PANEL - COWL SCREEN (REMOVE AND REPLACE) .
- Disconnect 12V power. See 12V/LV POWER (DISCONNECT AND CONNECT) .
- Remove the 12V auxiliary battery. See 12V/LV BATTERY (REMOVE AND REPLACE) .
- Remove the bolt that attaches the 12V battery rear hook tie down to the body, and then remove the tie down from the body.
- Remove the nuts (x2) that attach the superbottle to the thermal beam.
- Remove the upper bolts (x2) that attach the battery bracket to the vehicle.
- Release the clip that attaches the coolant hose to the 12V battery bracket.
- Release the clip that attaches the 12V battery vent hose to the 12V battery bracket.
- Loosen the inner bolts that attach the shock tower brace to the RH shock tower.
- Loosen the outer bolt that attaches the shock tower brace to the RH shock tower.
- Remove the inner bolts that attach the shock tower brace to the LH shock tower.
- Remove the outer bolt that attaches the shock tower brace to the LH shock tower.
- Shift the LH side of the shock tower brace towards the front of the vehicle to increase working space.
- Remove the bolt that attaches the thermal harness cover to the front body controller module, and then remove the cover from the module.
- Disconnect the thermal harness from the front body controller module connector.
- Release the clip that attaches the suction/liquid lines to the body near the TXV, and then move the electrical harness aside to gain access to the front body controller module.
- Remove the bolts (x9) that attach the front body controller module cover to the front body controller module, and then remove the cover.
- Disconnect the electrical harness from the front body controller module connectors (x4).
- Remove and discard the nuts (x6) and bolt that attach the power and ground cables to the front body controller module.
- Remove the bolts (x3) that attach the front body controller module to the body.
- Release the clips (x2) that attach the bottom of the front body controller module to the body, and then remove the lower busbar from the stud.
- Remove the bolt that attaches the ground strap to the upper rear of the front body controller module, and then remove the ground strap from the module.
- Remove the bolt that attaches the ground strap to the lower right side of the front body controller module, and then remove the ground strap from the module.
- Remove the bolt that attaches the ground strap to the lower rear of the front body controller module, and then remove the ground strap from the module.
- Remove the front body controller module from the vehicle.