Module - Body Controller - Security - Remove And Replace: Remove
WARNING: This page is about a different car, the 2024 Tesla Model X, 2023 Tesla Model X, 2022 Tesla Model X, and 2021 Tesla Model X. However, it is still accessible from the selected car via links, so may be relevant.
- Open the LH front door and lower the front windows.
- Move the driver seat rearward.
- Remove the LH sun visor bezel A-pillar trim. See Trim - A-Pillar - Sun Visor Bezel - LH (Remove and Replace)
- Remove the bolts (x2) that attach the LH upper A-pillar trim to the vehicle.
Tip:
Use of the following tool(s) is recommended:
- 13 mm socket
- Remove the screw that attaches the LH upper A-pillar trim to the vehicle.
Tip:
Use of the following tool(s) is recommended:
- 20 mm socket
- Remove and discard the nut that attaches the LH upper A-pillar trim to the vehicle.
Tip:
Use of the following tool(s) is recommended:
- 10 mm socket
- Release the clips (x6) that attach the LH upper A-pillar trim to the A-pillar, and then move the trim aside to gain access to the headliner.
- Remove the screw that attaches the LH front of the headliner to the vehicle.
2 N.m (1.5 ft-lbs)
Tip:
Use of the following tool(s) is recommended:
- Torx T20 socket
- Open the RH front door.
- Repeat step 2 through step 8 for the RH side of the vehicle.
- Release the clips (x4) that attach the front portion of headliner to the body, and then release the front edge of the headliner from the body.
- Disconnect the security body controller module electrical connector.
- Remove the bolt that attaches the security body controller module to the vehicle.NOTE: The bolt is captive inside the controller housing and cannot be removed.
Tip:
Use of the following tool(s) is recommended:
- Torx T30 socket
- Release the clip and guide pin that attach the security body controller module to the vehicle, and then remove the module from the vehicle.