NIPPONDENSO Electronic Ignition System: Testing: Overhaul: Reassembly

Assemble in reverse order, noting the following:

• Lightly grease timing rotor (reluctor) inner surface. Install on shaft aligning mark on stopper plate ("15.5" mark on Subaru; "10" mark on Celica, Corona, and Pickups; and "13.5" on Corolla) with stopper.
• When installing breaker plate, align 4 clips of plate with 4 grooves in housing.
• When replacing pinion, replace pin and pinion as a set.
• Adjust air gap between timing rotor and pick-up coil.